top of page
STRADALLI CARBON FIBER SHALLOW DROP AERO WING ROAD BARS BICYCLE 31.8 HANDLEBAR
s-l1600-54.jpg
s-l1600-55.jpg
s-l1600-56.jpg
s-l1600-53.jpg
s-l1600-57.jpg

Stradalli Cycle Full Carbon Fiber Shallow Drop Ergo Road Bike Bicycle Stem Handlebar Bar Aero Fino Phantom Compact 40 42 44 cm

​

Our new Fino Phantom Bar is one of the most Aerodynamic handlebars we have ever produced, yet maintains the stiffness known in our W-17 model.  The Stradalli Fino Phantom Bar works well with all shifters, and creates a leveled plane on the top of the bar for added comfort and low wind resistance.

​

100% HM Carbon Fiber Available in 40, 42, and 44cm (c to c)

Reinforced and textured clamping area for secure mounting
Textured handles for sturdy tape application.

Our quality is world class, competition rated.

Handlebars for 31.8mm stem
Drop/Reach 125mm/90mm

​

Stradalli cycle carbon fiber Handlebar Installation Instructions:

A. Measure the stem clamp diameter. The Stradalli cycle carbon fiber handlebar is only compatible with stems that have a 31.8mm clamp diameter.     

Remove all sharp edges and burrs on the stem clamp area. Failure to do so may result damage to the handlebar that can cause failure, loss of control of bicycle, injury or death.   

B. Apply Carbon fiber Installation Compound on stem and faceplate surfaces that contact the handlebar. 

C. Place the handlebar into the Stem Body and install the Face Plate, lightly tightening the Face Plate Bolts but do not tighten. 

Center and adjust the position of the handlebar. Stradalli cycle carbon fiber road handlebars are designed to be set up with the ends of the bars approximately horizontal (0° - 6°). This will give the best position for riding in the drops and short reach to the brake lever.   

D. Tighten stem face plate bolts according to stem manufacturer’s instructions.   

Tighten faceplate bolts only a ¼ turn at a time, alternating between the bolts in an “ X ” pattern. Failure to do so will result in damage to the handlebar that is not covered under warranty. 

​

Tighten the bolts to the Minimum amount of torque necessary to secure the handlebar. 

Do NOT exceed 60kgf.cm of torque. 60 kgf.cm / 6 Nm / 52 in.lbs, is the maximum torque for most M5 stem bolts. 

Failure to comply with these instructions may result in damage to the bar causing loss of control of bicycle, injury, or death.

​

Our quality is world class, competition rated.

Our prices leave competition in the dust.

Authentic Stradalli® product.

​

​

​

bottom of page